Sony MSW-M2100 Operation Manual page 94

11-4 Items in the Extended Setup Menu
Menu items in the range 250 to 299, relating to the network parameters (MSW-M2100E/M2100EP)
Item number Item name
250 MAX RATE
251 NO RF TIME
252 NET REGEN
253 E-MONI AUD
254 MXF D10 DEST
255 MXF PRX DEST
256 HTTP TR DUR
11-12
Chapter 11 Setup Menus
Settings
Set the maximum transfer rate to the network by the transmitting e-VTR.
Best effort : Send data at the maximum possible transfer rate.
1 Mbps to 50 Mbps: Limit the data transfer rate to the selected value.
Set the continuous playback time of a nonrecorded section when the material
transfer range is from the tape top to the tape end (transfer of the virtual file
&whole.mxf), or from the current position to the tape end (transfer of the virtual
file &current.mxf) to stop the transfer automatically when a nonrecorded section is
played back continuously for a specific length of time.
5 sec to 30 sec
Select whether to set file reception record (when a recorder is used) of a cassette
with a Tele-File memory label to NET REGEN mode (to lock the time codes in
recording to those of the transmission side of the network).
off : If a file is defined on a cassette tape for the first time with this setting, file
reception of all subsequent files on this cassette in a recorder will be executed
in Internal Regeneration mode of the recorder.
on: If a file is defined on a cassette tape for the first time with this setting, file
reception of all subsequent files on this cassette in a recorder will be executed
by locking the time code generator of the recorer to the time codes recorded
on the materials on the transmitting VTR.
Note
A cassette tape is set to the condition specified with this menu item when a file is
defined on the tape for the first time. Once the condition is determined for a tape,
file definition/recording on the tape will be executed in the same condition
regardless of this item 252 setting. To change the condition for the cassette, it is
necessary to remove all the files from the tape and set to the new condition.
Select the output audio channel of e-monitor.
track 1/2 : Audio track channels 1 and 2 are output.
track 3/4: Audio track channels 3 and 4 are output.
track 5/6: Audio track channels 5 and 6 are output.
track 7/8: Audio track channels 7 and 8 are output.
Select the registration number of the destination server for MXF D10
transmission, using the control panel.
1 to 5: Registration number of the server you registered in the Web window
Select the registration number of the destination server for MXF Proxy AV
transmission, using the control panel.
1 to 5: Registration number of the server you registered in the Web window
Set the duration of the MXF file to be sent to an http server.
20 sec to 180 sec (select from 20, 40, 60, 90, 120, 150 and 180 seconds)