Sony MSW-M2100 Operation Manual page 22

2-1 Control Panels
ENTRY button
Use this for setting DMC playback control points and
so on.
• To set a speed variation start or end point: Hold down
the STUNT IN button or STUNT OUT button, and
press this button.
• To set an on-air start or end point: Hold down the
PLAY IN button or PLAY OUT button, and press
this button.
• To send MXF files via a network: Hold down this
button, and press the PLAY button (MSW-M2100E/
M2100EP only).
• When the VTR is in File Transmission mode that
uses the control panel and the number of the
destination server has been selected, the host name or
IP address of the destination server can be displayed
in the time data display area 2 by pressing this button.
6 CUE/PLAY (cue up/playback) button
After setting an on-air start point (PLAY IN point) and
an on-air end point (PLAY OUT point), pressing this
button cues up the tape to the on-air start point. The
button then starts flashing to indicate that the unit is
ready for DMC playback operation. To start DMC
playback, press the button again.
7 LEARN button
After setting a speed variation start point (STUNT IN
point) and a speed variation end point (STUNT OUT
point), pressing this button makes the tape start
running. You can then use the search dial to vary the
tape speed, which is automatically stored in memory.
After thus storing the tape speed variation in memory,
pressing this button starts an automatic playback
between the speed variation start and end points at the
stored speed.
2-12
Chapter 2 Location and Function of Parts
qs Shot mark section
1 LIST button
2 REC/ERASE indicator
LIST GOOD SHOT MARK
REC/
3 MARK button
ERASE
1 LIST button
Use this button to read in and list shot marks.
2 REC/ERASE indicator
This lights in the state in which writing, amending, and
deleting of shot marks is enabled and flashes while a
shot mark is actually being written, amended or
deleted.
3 MARK button
Hold this button down for 2 seconds or more, to enable
writing, amending, and deleting of shot marks.