Sony MSW-M2100 Operation Manual page 45

4-2 Playback Procedures
See Section 11-2 "Setup Menu Operations" (page 11-2) for
details of setup menu operations.
For details of character information displayed on the video
monitor screen, see the descriptions of F4 (CHARA) in
function menu page 4 (page 10-6) and setup menu item 005
(page 11-5).
Carrying out playback in feed mode
Use the following procedure to carry out feed mode
playback.
Z
2
1
Setup menu item 111 (TSO PLAY) to FEED.
If the system supports double speed feed mode
playback, in MPEG IMX playback, you can set the
feed mode playback speed to 1 or 2 times normal
speed by rotating the MULTI CONTROL knob
with the DMC/FEED button held down. If the
option is not installed, feed mode playback speed
is 1 times normal speed.
2
Hold down the DMC/FEED button, and press the
PLAY button.
Both buttons light, and playback in feed mode
starts.
3
Where you wish to stop playback, press the STOP
button.
Playback stops.
4-6
Chapter 4 Playback and File Transfer
Speed display area
3 1
Auto feed playback
Auto feed playback is a function for feed mode
playback of the segment between a specified IN point
and OUT point.
By connecting this unit to a recorder VTR with a
RECEIVE STANDBY function (MAV-555/2000 etc.)
via the SDTI-CONTROL PANEL interface and
executing auto feed playback on this unit, you can
record the interval between the IN and OUT points on
the recorder.
1
On the HOME page of the function menu, set F4
(CTL/TC) to TC.
2
Start playback and, with the ENTRY button held
down, press the STUNT IN button at the point
where you want to set the IN point. To set the OUT
point, press the STUNT OUT button with the
ENTRY button held down.
3
With the DMC/FEED button held down, press
LEARN button. (Before starting, refer to step 1 of
the previous section "Carrying out playback in
feed mode" and set the feed mode playback speed.)
The VTR prerolls to a point 5 seconds before the
IN point (this can be changed with item 001 of the
basic menu) and starts auto feed playback.
Playback stops after postroll for 2 seconds beyond
the OUT point.
The segment between the IN and OUT points is
recorded on the recorder.