Toshiba e-studio 2555c Troubleshooting Manual page 13

Message
Cannot print this paper type
Set the other paper type
Change from this mode
Count over, cannot store
anymore
READY(*** TONER NOT
RECOGNIZED)
Check the toner cartridge
READY (SADDLE STITCH
TRAY FULL)
READY (CHECK SADDLE
STITCH STAPLER)
READY (CHECK SADDLE
STITCH STAPLER)
READY (CHECK STAPLER)
READY (CHECK STAPLER)
READY (HOLE PUNCH
DUST BIN IS FULL)
READY (FINISHER FULL)
READY (INNER TRAY FULL)
Cannot copy
Check DEPARTMENT
COUNTER
Add paper
Problem Description
Printing was attempted but
failed.
The paper could not be output
in the tray selected because
of a mismatch between the
paper type and the tray.
(Special paper, thick 4 paper
or thin paper tried to be output
on the lower receiving tray of
MJ-1107/MJ-1108.)
The number of originals to be
scanned has exceeded the
limit specified with the
department or user code
during scanning.
The toner cartridge indicated
by *** is not installed at all or
improperly so.
The terminal of the toner
cartridge is stained.
The recommended toner
cartridge is not being used.
The saddle stitch tray of the
finisher is full of paper.
Staple jam has occurred in the
stapler of the saddle stitch
unit.
No staples are left in the
stapler of the saddle stitch
unit.
Staple jam has occurred in the
stapler of the finisher.
No staples are left in the
stapler of the finisher.
Hole punch dust bin is full of
paper punchings.
The receiving tray of the
finisher is full of paper.
The exit tray of the equipment
is full of paper.
The number of originals to be
scanned has exceeded the
limit specified with the
department code during
scanning.
No paper is left in a drawer or
on the bypass tray.
1 TROUBLESHOOTING FOR THE HARDWARE
Corrective Action
Delete the failed print job, select the
appropriate tray for the paper, and perform
printing again.
Ask your administrator for details of setting
the limit for the number of copies.
Install the toner cartridge correctly.
P.52 "Replacing a Toner Cartridge"
Wipe the terminal with a soft cloth.
Use the recommended toner cartridge.
P.52 "Replacing a Toner Cartridge"
Remove the paper from the saddle stitch
tray of the finisher.
Remove the jammed staples.
P.50 "Staple jam in the Saddle Stitch
unit"
Refill the staples.
P.64 "Refilling Saddle Stitch unit
staples"
Remove the jammed staples.
P.46 "Clearing a Staple Jam"
Refill the staples.
P.61 "Refilling With Staples"
Remove the paper punchings.
P.70 "Cleaning the Hole Punch Dust
Bin"
Remove the paper from the receiving tray
of the finisher.
Remove the paper from the exit tray of the
equipment.
Ask your administrator for details of setting
the limit for the number of copies.
Set paper in the drawer or on the bypass
tray. The touch panel indicates which
drawer (or the bypass tray) has no paper.
To set paper, refer to the Copying Guide.
Messages Displayed on the Touch Panel 11