Troubleshooting; Specifications - JVC Compact Component System CA-MXK1R Instructions Manual

Troubleshooting

• If you are having a problem with your System, check this list for a possible solution before calling for service.
• If you cannot solve the problem from the hints given here, or the System has been physically damaged, call a qualified person, such as
your dealer, for service.
Symptom
No sound is heard.
Poor radio reception
The disc tray does not open.
The CD skips.
The CD does not play.
The cassette holder cannot be opened.
Unable to record.
Unable to operate the Remote Control.
Operations are disabled.

Specifications

Amplifier
Output Power
CA-MXK3R 50 W per channel, min. RMS, at 6
with no more than 10% total harmonic
distortion
CA-MXK1R 30 W per channel, min. RMS, at 6
with no more than 10% total harmonic
distortion
Input Sensitivity/Impedance (1 kHz)
AUX IN 300 mV/50 k
Speaker terminals 6 - 16
Phones 32 - 1 k
15 mW/ch output into 32
Cassette Deck Section
Frequency Response
Type I (NORMAL) 63 - 12,500 Hz
Type II (CrO ) 63 - 12,500 Hz
2
Wow And Flutter 0.15% (WRMS)
CD Player
CD Capacity 3 CDs
Dynamic Range 85 dB
Signal-To-Noise Ratio 90 dB
Wow And Flutter Unmeasurable
Tuner
FM Tuner
Tuning Range 87.5 - 108.0 MHz
29
EN
Possible Cause
• Connections are incorrect, or loose.
• Headphones are connected.
• The antenna is disconnected.
• The AM Loop Antenna is too close
to the System.
• The FM Wire Antenna is not prop-
erly extended and positioned.
• The AC power cord is not plugged in.
• Tray is locked.
The CD is dirty or scratched.
The CD is upside down.
During tape playing, the power cord
was unplugged.
Cassette record protect tabs are re-
moved.
• The path between the Remote Control
and the sensor on the Unit is blocked.
• The batteries have lost their charge.
The built-in microprocessor has mal-
functioned due to external electrical in-
terference.
,
Unit
,
Accessories
Power Specifications
Design and specifications are subject to change without notice.
VICTOR COMPANY OF JAPAN, LIMITED
Action
• Check all connections and make cor-
rections. (See pages 4 to 6.)
• Disconnect the headphones.
• Reconnect the antenna securely.
• Change the position and direction of
the AM Loop Antenna.
• Extend FM Wire Antenna to the best
reception position.
• Plug the AC power cord.
• Unlock the tray. (See page 18.)
Clean or replace the CD. (See page 28.)
Put the CD in with the label side up.
Plug in the power cord, and turn on the
System.
Cover holes on back edge of cassette
with tape.
• Remove the obstruction.
• Replace the batteries.
Unplug the System then plug it back in.
AM Tuner
Tuning Range (MW) 522 - 1,629 kHz
(LW) 144 - 288 kHz
Dimensions
CA-MXK3R 270 mm
(10-2/5"
CA-MXK1R 270 mm
(10-2/5"
Mass
CA-MXK3R Approx. 7.3 kg (16.1 lbs)
CA-MXK1R Approx. 6.8 kg (15.1 lbs)
AM (MW/LW) Loop Antenna (1)
Remote Control (1)
Batteries R6P (SUM-3)/AA (15F) (2)
FM Wire Antenna (1)
Power Requirements AC 230 V ~ , 50 Hz
Power Consumption
CA-MXK3R 105 W (power on mode)
Approx. 1 W (in ECO mode)
CA-MXK1R 70 W (power on mode)
Approx. 1 W (in ECO mode)
305 mm 438.5 mm (W/H/D)
12" 17-5/16")
305 mm 386 mm (W/H/D)
12" 15-1/4")
0401TTMCREHIT