Remove The Server From The Rack - HP ProLiant DL320e Gen8 v2 User Manual

Install the rack rail cable ties
11.

Remove the server from the rack

WARNING:
equipment:
Observe local occupational health and safety requirements and guidelines for manual
•
material handling.
• Get help to lift and stabilize the product during installation or removal, especially when the
product is not fastened to the rails. HP recommends that a minimum of two people are required
for all rack server installations. A third person may be required to help align the server if the
server is installed higher than chest level.
Use caution when installing the server in or removing the server from the rack; it is unstable
•
when not fastened to the rails.
IMPORTANT:
performing installation and maintenance procedures depends on the rail system used:
If using a ball-bearing rail system, you can perform most installations and maintenance by
•
simply extending the server from the rack.
If using a friction rail system, to perform installations or maintenance that requires access panel
•
removal, remove the server from the rack.
Power down the server (on page 14).
1.
Extend the server from the rack (on page 14).
2.
Remove the server from the rack. For detailed information, see the documentation that ships with the
3.
rack mounting option.
Place the server on a sturdy, level surface.
4.
("Installing the rack rail cable
This server is very heavy. To reduce the risk of personal injury or damage to the
The requirement of extending or removing the server from the rack when
ties" on page 27).
Operations 16