Kenwood TK-390 Service Manual page 6

TK-390
3-15. Mode (Enable/Disable)
The transceiver has many special modes mainly for main-
tenance.
· Self Programming mode
· Panel Test mode
· Clone mode
· Firmware Programming mode
· Version info.
It is possible to set enable/disable for each mode. We
recommend to set these mode to Disable after set up to
save contents.
3-16. ID
The transceiver is capable to have ID. The format is
DTMF, MSK or ANI board (if installed). The timing that the
transceiver sends ID is programmable.
Connect ID : Connect ID is send on beginning of trans-
mission.
Disconnect ID : Disconnect ID is send on end of trans-
mission.
Both : Connect ID is send on beginning of transmission
and disconnect ID is send on end of transmission.
Off : Sending ID function is disabled.
There is also "PTT ID" setting for each channel. Refer
"PTT ID" of channel feature.
When you use an ID code for ANI board, the ID code and
transmitting timing are configured to the optional ANI board.
3-17. OST (Operator Selectable Tone)
The transceiver is capable to have "OST" function and
16 tone pair (QT/DQT) with max 7-digit name for each tone
pair.
• "OST" Back Up
The transceiver is programmable the selected "OST"
code is memorized or not. If you set to Disable (no memo-
rized), the "OST" function always starts at "off".
• Direct "OST"
It is possible to call "OST" number directory using key-
pad. In this case, keypad is used for "OST", then "DTMF
Auto PTT", "DTMF Auto Dial" functions by keypad are not
usable.
3-18. Emergency
• Active Time
Automatic transmission period in the emergency mode.
• Interval Time
Interval time between the automatic transmissions.
• Duration of Locator Tone 1
Duration of an alert tone before the automatic transmis-
sion is performed.
• Duration of Locator Tone 2
Duration of an alert tone after the automatic transmission
is performed.
6
OPERATING FEATURES
• Man Down Delay Time
internal Man Down port becomes active.
• Man Down Pre-alert
port becomes active to enter the emergency mode. (After
an alarm sounds, the transceiver waits for the programmed
wait time then enter the emergency mode.)
• Emergency Channel Display
GENCY" channel name when it is in emergency mode.
lected group/channel/status before entering to the emer-
gency mode however the transceiver is in an emergency
mode.
• Emergency Mode Type
• Emergency Type
board or OFF (Disabled).
• Emergency DTMF ID
gency type.
• Emergency Call Fleet
the emergency type.
• Emergency Call ID
the above emergency type.
3-19. Radio Password (Keypad Model Only)
tion. Every time the power on, transceiver is locked and
unusable until entering correct password.
causes the transceiver unlocked.
3-20. Data Password
programmed transceiver data by FPU. Enter pre-pro-
grammed password in FPU reading process. This password
also protects the clone.
clone.
Delay time of entering the emergency mode when the
Wait time of the alert tone when the internal Man Down
Setting for the display in the emergency mode.
The transceiver can be programmed to display "EMER-
If you set to "off" by KPG-38D the transceiver shows se-
Speaker mute on or off in the emergency mode.
Select an Emergency code format from DTMF, MSK, ANI
The Fleet number when you select DTMF in the emer-
The emergency fleet number when you select MSK in
The emergency DTMF ID code when you select MSK in
The radio password prevent unauthorized users opera-
Enter pre-programmed password by FPU and [#] key
The data password prevents unauthorized reading of the
Enter pre-programmed password by FPU and [#] key to