Sharp MZ-700 Series Owner's Manual page 109

3.2.2 Connecting the MZ-1D0412-inch green display
to the computer
Use the cable included with the MZ-1D04 green display to connect it to the computer. Plug the cable
into the composite signal jack on the computer's rear panel, then set the B/W-COLOR switch to the B/W
position.
fttiiiiutmiimiiiiitittttttti
i i i i i i i i i m i i i i i i i i n i n m u n
Rear panel of the MZ-700 series computer Rear panel of the MZ-1 D 0 4
3.2.3 Connecting the MZ-1 D0514-inch color display
to the computer
Use the cable included with the MZ-1D05 color display to connect it to the computer. Plug the cable's
DIN connector into the RGB signal output connector on the MZ-700.
Rear panel of the M Z - 7 0 0 series computer
R e a r
P
a n e l o f t h e
MZ-1 D05
Pin assignments of the RGB signal output connector of the MZ-700 are as shown below.
GREEN
BLUE
c s Y N c H f e £ V 5 C i m ~ c
VIDEO
GND
RGB signal o u t p u t D I N connector
(viewed f r o m the rear side)
VSYNC
HSYNC