Other; Attaching A Flush Mounted Ceiling Bracket (Optional Wb-S575) - JVC TK-C655 Instructions Manual

Other

Attaching a Flush Mounted Ceiling Bracket (Optional WB-S575)

The Flush Mounted Ceiling Bracket (optional WB-S575) allows the camera to be installed flush with the ceiling surface. In this case
the ceiling material should have a thickness of between 5 mm and 31 mm.
Anchor bolt mount holes
Clamping screw
Clamping
screw
Mounting screws (x 4)
(1)
Clamping screw
(2)
Stoppers
Anchor bolt mount
(3)
34
Mounting hole
3 positions
Loosen
Clamping
bracket
Clamping
screw
1.
Make a hole (diameter 200 mm) in the ceiling.
2.
Prepare the Flush Mounted Ceiling Bracket.
• Fully loosen the clamping screws (by turning them anti-clockwise).
• Move the clamping brackets towards the inside as shown in the
diagram.
• Remove the four mounting screws.
3.
Clamp the Flush Mounted Ceiling Bracket.
(1) Fit the Flush Mounted Ceiling Bracket into the hole in the ceil-
ing.
(2) Ensure that the stoppers are pressing against the back of the
ceiling plate.
(3) Push the Flush Mounted Ceiling Bracket all the way up and tight-
en the three clamping screws (by turning them clockwise).
CAUTION
• Make sure that the clamping brackets grip the ceiling plate firmly.
• If the Flush Mounted Ceiling Bracket rattles after the clamping
screws are tightened, loosen them fully and tighten them again.
If anchor bolts can be used, attach them using M8 - M10 (or 3/8 inch)
nuts.