Point-To-Point Communication System - JVC TK-C655 Instructions Manual

Connections & Installation

Point-to-Point Communication System

The following illustration shows a system in which a remote control unit (or a similar piece of equipment) controls a single camera.
Video out
Control signal cable
Switch 4 : OFF
(Point to Point)
Switch 8 : ON
(Terminated 110Ω)
Observe the following points when connecting system components :
• Turn all the components power off before proceeding.
• Read the instruction manuals of each component before above proceeding.
Cable connections
(Connector side of the Ceiling Mount)
Control signal cable
MEMO
If this camera or the cables connected to this camera are used in places subject to strong electromagnetic waves or other forms
of magnetism, for example near a radio or TV transmitter, a power transformer or an electric motor, the picture may suffer from
noise and colours may be affected.
In order to operate and control the TK-C655 camera, a separate control unit accessory is required. Please contact JVC author-
ized dealer or installer for more information about these controllers.
10
AC 24 V
power supply
☞
P. 14
To controller
Coaxial cable
To monitor
To the AC 24V power supply
Power cable
☞
Switch settings
(Setting switches on the Ceiling Mount: Setting switch side)
Setting not Setting not
required required
Monitor
Controller
P. 12
Switch 1 : OFF
Switch 2 : OFF
Switch 4 : OFF
Switch 5 :
Configure in
accordance with the requirements
of the controller communication
system.
Switch 7 : OFF
Switch 8 : ON