JVC TK-C655 Instructions Manual page 17

Ceiling Mount
Camera
Camera clamping bracket
Lock screw
Tighten the locking screw.
Locking screw
Camera clamping
bracket
Rotate the camera
clockwise.
2.
Ensure that the locking screw is loose.
The camera cannot be attached properly if the locking
screw of the Ceiling Mount is too tight at this stage.
3.
Fit the camera.
Check the position of the camera clamping bracket and
that of the locking screw, and fit the camera to the Ceiling
Mount.
4.
Rotate the camera.
Make sure that the camera is horizontal, then turn the
camera clockwise until it stops. Ensure that the camera-
clamping bracket is in line with the locking screw of the
Ceiling Mount.
5.
Tighten the locking screw.
Tighten the lock screw using a Phillips screwdriver.
CAUTION
If the locking screw is not tightened firmly, the camera may vi-
brate or come loose. Be sure to tighten the locking screw firmly.
* To remove the camera from the Ceiling
Mount, reverse the steps
1 5
to .
17