Table of Contents
Advertisement
E
Camera Type For specifying whether the camera corresponding to the selected number is [Fixed] or [Moveable].
Fixed
Moveable
F
This option is enabled only if Moveable is selected in the [Camera Type] item E.
Device Port
For specifying which control port on the network encoder (IP video server) to use for controlling the PTZ features.
G
This option is enabled only if Moveable is selected in the [Camera Type] item E.
Port Addr.
Use this option to specify the port address of the camera. The port address is usually set to 0 or 1 .
If the PTZ cameras are serially connected, they are identified by their the port addresses. Refer to the camera's
[INSTRUCRTIONS] for the recommended settings.
[CAMERA CONTROL] Terminal at the Rear
of VR-N900U (VR-N900U)
The analog camera acts as a network encoder (IP video server) in
the VR-N900U system, and the device name assigned to it is
[N900]. The [CAMERA CONTROL] terminal at the rear is assigned
as COM1 on the Camera Settings screen.
(A Page 88)
: Fixed Camera
: PTZ Camera
Advertisement
Table of Contents
