Camera Control Terminal (Vr-N900U); Differences When Operating Vr-N1600U/E And Vr-N900U; Mounting To A Rack - JVC LST0728-001B Instructions Manual

Camera Control Terminal (VR-N900U)

Use connection cables according to the table below. Also make
sure that you read through the instruction manual of the equipment
to be connected.
Signal
RX+
RX-
TX-
TX+
GND
NC
NC
NC
NC
(D-sub 9 pin, male)
Differences when
operating VR-N1600U/E
and VR-N900U
The name of control buttons and operating methods may vary
between VR-N1600U/E and VR-N900U. Such circumstances will
be indicated using the rules below.
When name of control button is different
A
Indicated accordingly using [button name of VR-
N1600U/E] and (button name of VR-N900U)
B
mark is inserted at the end of the sentence
Press the [16/ENTER](ZOOM IN/ENTER)button.
When operating method is different
The operation for the respective model is stated, and the model
name is indicated at the end of the sentence.
Pin No.
1
2
3
4
5
6
7
8
9
A

Mounting to a Rack

Use the supplied rack mount bracket to mount this unit to the EIA
rack. For the installation to the rack, consult the specialist or dealer.
1
Mount the rack mount bracket using screw (1)
● Use the 4 screws (M4 x 10 mm) supplied to fasten this unit
at the two sides.
2
Remove the foot screws B (4 pcs) at the bottom
of the unit
● Remove the foot.
3
Mount to the rack using screws C
● Use the 4 screws (M5 x 11 mm) supplied to fasten this unit
to the rack.
Rack Mount
Bracket
Note :
● Do not place any object on this unit when it is mounted to the
rack. Doing so may cause it to lose balance and drop or fall,
B
hence resulting in injuries or damages.
● When mounting more than one of this unit to the rack, make sure
to mount each at a distance that is at least equivalent to one
unit.
● When remounting the removed foot, make sure to use same
screws (M3x6 mm). Using a longer screw may cause
malfunction.
(4 Screws)