1. INSTALLATION
1.1 INSTALLATION REQUIREMENTS
1.1.1 ENVIRONMENT [ALL MODELS]
1. Temperature Range:
2. Humidity Range:
3. Ambient Illumination:
4. Ventilation:
5. Avoid areas that are exposed to sudden temperature changes. This includes:
1) Areas directly exposed to cool air from an air conditioner.
2) Areas directly exposed to heat from a heater.
6. Do not install this machine in an area where it will be exposed to corrosive
gases.
7. Do not install the machine at locations over 2,500 m (8,125 ft.) above sea level.
8. Put the machine on a strong and level base. Inclination on any side should not
exceed 5 mm.
9. Do not put the machine where it may be subjected to strong vibrations.
1.1.2 MACHINE LEVEL [ALL MODELS]
Front to back:
Right to left:
1.1.3 MACHINE SPACE REQUIREMENT [ALL MODELS]
Place the machine near the power source, providing the clearance as shown
below:
A: Over 10 cm (4 inches)
B: Over 10 cm (4 inches)
C: Over 100 cm (40 inches)
D: Over 10 cm (4 inches)
SM
10 °C to 32 °C (50 °F to 89.6 °F)
15 % to 89 % RH
Less than 2,000 lux (do not expose to direct sunlight).
3 times/hr/person
Within 5 mm. (0.2 inches) of level.
Within 5 mm. (0.2 inches) of level.
A
1-1
INSTALLATION REQUIREMENTS
B
C
D
G094I500.WMF
G112/G113/G116/G094/G095/G091