Printer Controller Board [All Models] - Ricoh G112 Service Manual

PRINTER CONTROLLER BOARD [ALL MODELS]

3.10 PRINTER CONTROLLER BOARD [ALL MODELS]
The board for the G112/G094 is different from the board for the G113/G095. Make
sure to install the correct board.
NOTE: 1) Remove the Duplex Unit before
you remove the controller
board. [G116/G091 machine
only]
2) The screws on the printer
controller board are hand
screws. Gently turn these
screws when removing the
printer control board.
3) Pull on the handle to remove
the printer controller board from
the machine.
[A]: Printer controller board ( x 2)
[B]: NVRAM
NOTE: Remove the NVRAM from the
old printer controller board
and insert it on the new board.
G112/G113/G116/G094/G095/G091
[A]
3-24
G094R005.WMF
[B]
SM