Hi Power Mode; Filter Indicator; Short Timer - Toshiba RAS-22N3KV2-A Service Manual

Item
18. Hi-POWER
([Hi-POWER] button on the remote controller
Mode
is pressed)
When [Hi-POWER] button is pressed while the indoor
unit is in Auto, Cooling or Heating operation, Hi-
POWER mark is indicated on the display of the remote
controller and the unit operates as follows.
1. Automatic operation
2. Cooling operation
3. Heating operation
4. The Hi-POWER mode can not be set in Dry
19. FILTER
When the elapsed time reaches 1000 hours after
Indicator
conditioner operation, the FILTER indicator lights.
After cleaning the filters, turn off the FILTER indicator.
How to Turn Off FILTER Indicator
Press [RESET] button on the indoor unit.
NOTE :
If [RESET] button is pushed while the FILTER indicator
is not lit, the indoor unit will start the automatic
operation.

20. Short Timer

In the normal condition, after switching one
circuit breaker, 3-minute delay time for
compressor and 1 hour for plasma air purifier
are set for the maintenance of the unit.
Operation flow and applicable data, etc.
• The indoor unit operates in according to the
current operation.
• The preset temperature drops 1ºC
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increase 1 tap
• The preset temperature increases 2ºC
(The value of the preset temperature on the
remote controller does not change.)
The indoor unit's fan speed level increase 1 tap
operation
SWING FA N
ONE-TOUCH FIX QUIET
Hi POWER
COMFORT
SLEEP
∗ The Hi-POWER operation will be cancelled
when press [Hi-POWER] button again.
Purpose
To start the unit immediately for the
purpose of testing, trial...etc, short timer
can be used maintenance of the unit.
Short Timer Setting
Q
Push [
R
Set the operation mode or plasma air
purifier on the remote controller without
sending the signal to the unit.
S
Use the tip of the pencil to push the
2
[CHK] button and hold, "00" will show
on display, then push [SET] button to
make "00" disappear.
T
Push [
U
When short timer is activated, all setting
on the remote controller operates
1
immediately, besides, all indicatiors on
front panel turn ON continuously for
3 seconds.
− 41 −
FILE NO. SVM-13003
Description
] button to turn the unit OFF.
] button to turn the unit ON.