Operating Procedure - Brother HL-3040CN Service Manual

<Operating procedure>
(1) Press the or
the maintenance mode. Then, press the OK button.
(2) The machine displays "WSW00" on the LCD and becomes ready to accept a worker
switch number.
(3) Press the or
Then, press OK button.
(4) The following appears on the LCD.
Selector 1
(5) "1" is set by pressing the
Press the button if you want to input "1" to the selector 1 and press the
want to input "0."
(6) The cursor moves to the right onto the selector 2. Repeat to enter the desired number as
described step (5) until the modification for the desired worker switches is completed till
the selector 8. Press the Back button to go back to the previous selector if there is a
mistake. Then, enter the desired number again.
(7) Press the OK button when the setting value is entered. This operation saves the newly
entered selector values onto the EEPROM and readies the machine for accepting a
firmware switch number.
The machine displays "WSW00" on the LCD again to accept a worker switch number.
(8) Press the Cancel button to return to the machine to the initial state of the maintenance mode.
Memo:
- To cancel this operation and return to the machine to the initial state of the maintenance
mode during the above procedure, press the Cancel button.
- If there is a pause of more than one minute, the machine will automatically return to the
initial state of the maintenance mode.
button to display "MAINTENANCE 10" on the LCD in the initial state of
button to select the desired number from the worker switch numbers.
Selector 8
button and "0" is set by pressing the
7-6
button.
button if you
Confidential