Brother HL-3040CN Service Manual page 162

(4) Assemble the Fuser cover R to the Fuser unit with the Taptite bind B M3x12 screw.
Note:
Do not pinch the harness from the low-voltage power supply PCB ASSY to the Fuser
unit.
Fuser cover R
Taptite bind B M3x12
<Back side>
(5) Assemble the Fuser cover L to the Fuser unit with the Taptite bind B M3x12 screw.
Note:
Mount the Fuser cover L as holding down the harness of the thermistor to the Side
frame L side. (If the harness is protruded, it hooks up the eject front actuator.)
Fuser unit
Fig. 4-17
Side frame L
Fuser unit
<Back side>
Fig. 4-18
4-12
Fuser cover L
Taptite bind B M3x12
Confidential