Navigator Setting (Device) - JRC JMA-9172-SA Instruction Manual

JMA-9172-SA Instruction Manual
2) Open the Serviceman Menu.
Perform the following menu open procedure to open the Range
3)
Adjustment menu.
For inputs to the value input screen, refer to Section 3.3.4.3 "Increasing or decreasing a
numeric value".
Adjust the range adjustment value by operating the
4)
button so that the target measured in step 1) falls in the correct
range.
Left-click the
5)
7.1.6

Navigator Setting (Device)

Determine whether to connect navigators to the radar equipment.
Only the navigators set to ON here can be used.
Procedures
1) Open the Serviceman Menu.
Perform the following menu open procedure to open the Device
2)
Installation menu.
Select
3)
and
>
7.SETTINGS FOR SYSTEM OPERATION
1. Adjust Menu
→ 3. Range Adjustment
button to determine the value.
ENT
2. Installation Menu
9. Next
→
3. Device Installation
→
for navigators connected to the radar equipment,
On
for navigators not connected.
Off
Gyro： Gyro (via GYRO I/F)
Compass： Compass (Compliant with IEC61162)
GPS Compass： GPS Compass (JRC)
LOG： Log (via GYRO I/F)
2AXW： 2-axis log (Speed over water: Compliant with IEC61162)
2AXG： 2-axis log (Speed over ground: Compliant with IEC61162)
>
7.1 SETTINGS AT INSTALLATION
7 － 6
/
＋
－