Table of Contents
Advertisement
Service Program
Rapid reading of alarm codes
1
2
3
The last alarm code can be displayed even if the programme selector is not in the 10th position
(service test mode) or if the appliance is in normal operating mode (e.g. during the execution of an
washing programme):
-
Keep buttons 1 and 2 pressed in together.
Then the LEDs indicate the error code by flashing sequently.
-
-
The alarm sequence continues as long as the two buttons are held down
-
While the alarms are displayed, the appliance continues to perform the cycle or, if in the
programme selection phase, maintains the previously-selected options in memory.
Cancelling the last alarm
-
Enter service test program (page 23)
-
Press buttons 1 and 2 in together and keep them pressed in until the signal buzzer is heard
once (all LEDs off).
It is good practice to cancel the last alarm:
-
after reading the alarm code, to check whether the alarm re-occurs during diagnostics
-
after repairing the appliance, to check whether it re-occurs during testing.
DGS-TDS-N 11.06 R.B.
4
5
© Electrolux
- 29 -
599 51 50 25
EN
Hide quick links:
Advertisement
Table of Contents
