Pioneer VSX-1017AV-K Service Manual page 18

1
A
7 TV CONTROL buttons
These buttons are dedicated to control the TV assigned to
the TV CTRL button. Thus if you only have one TV to hook
up to this system assign it to the TV CTRL input source
button. If you have two TVs, assign the main TV to the TV
CTRL button (see page 57 for more on this).
TV – Use to turn on/off the power of the TV.
TV VOL +/– – Use to adjust the volume on your TV.
INPUT SELECT – Use to select the TV input signal.
TV CH +/– – Use to select channels.
8 Component control buttons
The main buttons (,, etc.) are used to control a
B
component after you have selected it using the input
source buttons.
The controls above these buttons can be accessed after
you have selected the corresponding input source button
(for example DVD,DVR1 or TV). The following controls
can be accessed when listening to the built-in tuner:
MPX – Switches between stereo and mono reception
of FM broadcasts. If the signal is weak then switching
to mono will improve the sound quality.
DISP – Switches between named station presets and
radio frequencies. Also used to display RDS
information.
C
EON – Use to search for programs that are
broadcasting traffic or news information.
9 Receiver controls
THX – Press to select a Home THX listening mode.
STANDARD – Press for Standard decoding and to
switch between the various
Neo:6 options.
ADV.SURR – Use to switch between the various
surround modes.
STEREO/F.S.SURR – Switches between the stereo
playback mode and the Front Stage Surround
D
Advance mode.
AUTO SURR – Press to select the Auto Surround
mode or the Stream Direct mode.
Stream Direct playback bypasses the tone controls
and any other signal processing for the most
accurate reproduction of a source.
ACOUSTIC EQ – Press to select an Acoustic
Calibration EQ setting.
SIGNAL SEL – Use to select an input signal.
E
F
18
1
2
10 MULTI OPE
Use this button to perform multi operations.
11 SHIFT
Press to access the controls outlined in white boxes (for
example, INPUT SELECT
selected input source in the remote control LCD.
12 SOURCE
Press to turn on/off other components connected to the
receiver.
13 Character display (LCD)
This display shows information when transmitting
control signals.
The following commands are shown when you're setting
the remote to control other components:
SETUP – Indicates the setup mode, from which you
choose the options below.
PRESET – See Selecting preset codes directly.
MULTI OP – See Multi Operation and System Off.
SYS OFF – See Multi Operation and System Off.
DIRECT F – See Direct function.
RESET – See Resetting the remote control presets.
READ ID – See Confirming preset codes.
14 RECEIVER
Switches the remote to control the receiver (used to
select the green commands above the number buttons
(ANALOG ATT, etc.)). Also use this button to set up
surround sound.
15 VOL +/–
Pro Logic IIx and
Use to set the listening volume.
16 MUTE
Mutes the sound or restores the sound if it has been
muted (adjusting the volume also restores the sound).
17 EFFECT/CH SEL and LEVEL +/–
Press repeatedly to select a channel, then use +/– to
adjust the level. Also adjusts the level of the Advanced
Surround effects, the Dolby Pro Logic IIx Music and
Neo:6 Music parameters and the sound delay setting.
You can then use the +/– buttons to make these
adjustments.
VSX-1017AV-K
2
3
), or to display the currently
3
4
4