Sharp Aquas LC-52LE920UN Operation Manual page 38

On-Screen Display Menu
• Updating the Software via the Network
1
Press
~/~
on the Manual Update screen to select
"Network Update", and then press
ENTER.
• The 1V connects to the network and checks for updates.
• To cancel, press ENTER.
2
The current version of the 1V and the latest version
of firmware are displayed. To update the 1V
software, select "Yes", and then press
ENTER.
• When a server connection cannot be established or an
update is not available, a message is displayed.
If a server connection cannot be established, check the
broadband connection and Internet Setup.
Cannot reach the server
Check the network settIngs
and
try
again
~
There
IS
no newer software
than the present versIon
~
3
After the update file is downloaded, the software
update process begins.
~
• Do not unplug the AC cord while the software is
being updated.
4
When the software is successfully updated, a
screen is displayed indicating that the upda:e
process is completed.
Press
ENTER.
The 1V restarts, and it takes a while until the system
update is completed. Do not unplug the AC cord.
• If the software was not updated successfully, check the
broadband connection and Internet Setup, and then try
updating the software again.
Failed to complete update
Please retry from Software
Update menu.
~
• Updating the Software with a USB Memory Device
To check for the availability of a software update, visit
http://www.sharpusa.com/products/support/. If you
have any questions, please
call 1-800-BE-SHARP (800-237-4277).
~
• Do not remove the USB memory device or unplug
the AC cord while the software is being updated.
• Be sure to properly follow the whole procedure
described below, step by step. Otherwise, for
example, the TV cannot read the data in the USB
memory device and software updating will fail.
1
Insert the USB memory device with the upd3.te file
into the USB 1 or USB 2 terminal on the 1V.
• When you update the software, use only one LSB
terminal. Either USB 1 or USB 2 is usable.
2
Press
~/~
on the Manual Update screen to select
"USB Memory", and then press ENTER.
@)-
37