2.
Pass the media through the printer and secure it in place so that no slack occurs.
Pull out the media, pass its leading edge through between the pinch rollers and the grit
rollers, and feed it through as far as the platen.
Make sure the edge of the media lies along the guide line.
Hold the media at the center and pull it out, being sure to keep it straight.
Make sure all areas of the media are taut.
CLOSE FRONT
COVER
Lower the loading lever to hold the
media in place.
starts to flash, and then the screen shown in the figure appears.
2-2 Loading and Cutting Off Media
Guide line
Chapter 2 Operation
35