Connection For P608; Connection For J602; Connecting Connector Assemblies - Furuno FCR-2139S-BB Installation Manual

4. Connect the GYRO CONVERTER board and J602 with two connector assemblies
03-2089 and 03-2090.

Connection for J602

2
PPL
From J4
BLU
GRN
YEL
ORG
RED
From J5
BRN
2 VH connector assy.
03-2089 (5P)
2 VH connector assy.
03-2090 (3P)
P5
5. Confirm gyrocompass specifications and set up the DIP switches and jumper
wires on the GYRO CONVERTER board according to gyrocompass connected:
• Setting jumper wires and DIP switches by gyrocompass specifications: page 4-
5
• Setting jumper wires and DIP switches by make and model of gyrocompass:
page 4-7
• Location of jumper wires and DIP switches: page 4-8
6. Pass gyrocompass cable through the cable clamp and connect it to connector
J602 as shown in the figure on page 4-3.
4. INSTALLING OPTIONAL EQUIPMENT (for RADAR)
Wiring for WAGO connector
Press downward.
Terminal opener
WAGO connector
Twist
Wire
Procedures
1. Twist the cores
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
5. Pull the wire to confirm that it is
secure.
To J602
To P608
P4
J5
J4
P608
J603
TB
03P9342

Connecting connector assemblies

Connection for P608

1
P608
1 NH connector assy.
03-2091 (5P)
XH-PH connector assy.
03-2088 (6-14P)
P7
P603
GYRO CONVERTER
J1
64P1106A
J7
J602
YEL
ORG
RED
P1
4-3