Connection Of External Power Supply; Attaching Plastic Cover For Gyro Converter Board - Furuno FCR-2139S-BB Installation Manual

4. INSTALLING OPTIONAL EQUIPMENT (for RADAR)
7. Attach the clamps on the plastic cover and then attach the cover to the GYRO
CONVERTER board as shown in the figure below. Insert cables to the clamp
EDS-1, respectively.
Clamp EDS-1
Insert cables to these
clamp.

Attaching plastic cover for GYRO CONVERTER board

8. Close the radar processor unit.
4.1.2

Connection of external power supply

An external power supply is necessary when the repeater signal is step-by-step type
and the step voltage is below 20V or output voltage is less than 5W.
1. Cut jumper wire JP1 on the GYRO CONVERTER board when an external power
supply is used.
4-4
Plastic cover
Screw
M4X8 3 pcs
Clamp CKS-10-L
Clamp CKS-13-L