2
Technology > Embedded RDS > E-RDS Setup > Network settings
E-RDS Setup
To monitor a Copier/ MFP with e-Maintenance/ imageWARE Remote, the following settings
are required.
Advance preparations
(1) Advance confirmation
Confirm with the UGW administrator that the device to be monitored with e-Maintenance/
imageWARE Remote is registered in the UGW.
(2) Advance preparations
Interview the user's system administrator in advance to find out the following information
about the network.
Information item 1
IP address settings
•
Automatic setting (DHCP, RARP, BOOTP)
•
Manual setting IP address, subnet mask and gateway address to be set
Information item 2
Is there a DNS server in use?
If there is a DNS server in use, find out the following.
•
Primary DNS server address
•
Secondary DNS server address
Information item 3
Is there a proxy server?
If there is a proxy server in use, find out the following.
•
Proxy server address
•
Port No. for proxy server
Information item 4
Is proxy server authentication required?
If proxy server authentication is required, find out the following.
•
User name and password required for proxy authentication
2
Technology > Embedded RDS > E-RDS Setup > Network settings
Network settings
Based on the results of the information obtained in (2) Advance preparations, make the iR
device network related settings in accordance with the following procedures.
IP Address Settings
a. Move on to Settings/ Registration > System Settings > Network Settings > TCP/IP Settings
> IPv4 Settings > IP Address Settings.
b. Set the IP address, based on the information obtained under (2) Advance preparations,
Information item 1, described above.
•
For automatic acquisition, select from [DHCP], [RARP], [BOOTP].
•
For manual setting, set the following by numeric keys.
•
IP Address
Example) 172. 001. 016. 200
•
Subnet Mask
Example) 255. 255. 255. 0
•
Gateway Address
Example) 172. 001. 016. 254
2-72
F-2-100
F-2-100
F-2-101
F-2-101
2-72