Software Counter; Fan - Canon imageRUNNER 2530 Service Manual

2
Technology > Controller System > Controls > Fan

Software counter

The timing at which the count is incremented differs depending on the following:
- Printing mode (single-sided/double sided (2nd side) or double sided (1st side))
- Target of delivery (inner finisher)
Single-sided/Double-
Target of delivery
1st delivery tray
No.1 delivery sensor (S12)
Host machine
2nd delivery tray
No. 2 delivery sensor (S42)
Inner finisher
Inner finisher inlet sensor (S1)

Fan

Overview
Fan layout
FAN6
2 Technology > Controller System > Controls > Fan
Print mode
Double-sided (1st side)
sided (2nd side)
Count-up timing
Duplex feed sensor (S7)
FAN3
FAN4
F-2-42 F-2-42
No. Name
FAN3
Exhaust fan (rear)
FAN4 Exhaust fan (front)
FAN6 Power supply cooling fan
WUP
Exhaust fan (rear)
(FAN3)
Exhaust fan (front)
T-2-9 T-2-9
(FAN4)
Power supply cooling fan
(FAN6)N6)
*1: The fan operates at 1/2 speed only when the machine enters the standby mode after
running for more than 8 minutes for fixing.
Function
Cools the fixing unit.
Cools the fixing unit.
Cools the power supply.
STBY INI PTINT LSTR
60sec
: 1/2-speed
：Full-speed
2-24
Error code
E805-0000
E805-0001
E805-0002
E805-0003
E804-0000
E804-0001
T-2-10 T-2-10
STBY
*1
F-2-43 F-2-43
2-24