Dinli DL-801 Service Manual page 78

ENGINE
● Measure the movable drive face bushing I.D.
Service Limit: ψ27.06mm replace if over
ASSEMBLY
● Install the weight rollers into the movable drive face.
● Install the ramp plate.
● Check the drive pulley collar for wear or damage.
● Measure the O.D. of the drive pulley collar sliding surface.
Service Limit: ψ26.94mm replace if below
INSTALLATION
● Install the drive pulley face assembly and collar.
● Reverse the Removal procedure to install the drive pulley,
wash and nut.
NOTE:
When installing the drive pulley face, compress it to let the
drive belt move downward to the lowest position so that the
drive pulley can be tightened. Install the washer with the "OUT
SIDE" mark facing out. DO NOT get oil or grease on the drive
belt or pulley faces.
【6-23】