Tires Inspection - Dinli DL-801 Service Manual

WHEELS/TIRES
●Support the wheel rim [A] on a suitable stand [B] to
prevent the tire from slipping off.
●Inflate the tire until the tire beads seat on the rim.
Maximum Tire Air Pressure ( to seat beads when cold )
Front and Rear: 250kpa (2.5 kgf-cm
Do not inflate the tire to more than the maximum tire
air pressure. Over inflation can explode the tire with
possibility of injury and loss of line.
●Check to see that rim lines [A] on both sides of the tire are
parallel with the rim flanges [B].
★If the rim lines and the rim flanges are not paralleled,
deflate the tire, lubricate the sealing surfaces again, and
re-inflate the tire.
●After the beads are properly seated, check for air leaks.
○Apply a soap and water solution around the tire bead and
check for bubbles.
●Deflate the tire to the specified pressure.
●Check the tire pressure using an air pressure gauge.
Tire Air Pressure (when cold)
Front: 50 kPa (7.0 psi)
Rear:
●Install the wheel (see Wheel Installation).
●Wipe off the soap and water solution on the tire and dry the
tire before operation.
Do not operate the vehicle with the water and soap still
around the tire beads. They will cause tire separation,
and a hazardous condition may result.
Tire Inspection
●Examine the tire for damage and wear.
○If the tire is cut or cracked, replace it.
○Lumps or high spots on the tread or sidewalls indicate
internal damage requiring tire replacement.
○Remove any foreign objects from the tread. After removal,
check for leaks with a soap and water solution.
○Check the shape of the tread knobs. If no vertical side is left
on the drive side of the knobs, replace the tire.
2
, 36 psi )
△WARNING
50 kPa (7.0 psi)
△WARNING
【2-8】