Dinli DL-801 Service Manual page 10

(7) Edges
Watch for sharp edges, as they could cause injury through careless handing, especially during
major engine disassembly and assembly. Use a clean piece of thick cloth when lifting the
engine or turning it over.
(8) High-Flash Point Solvent
A high-Flash point solvent is recommended to reduce fire danger. A commercial solvent
commonly available in North America is standard solvent (generic name). Always follow
manufacturer and container directions regarding the use of any solvent.
(9) Gasket, O-Ring
Replace a gasket or an O-ring with a new part when disassembling. Remove any foreign matter
from the mating surface of the gasket or O-ring to ensure a perfectly smooth surface to prevent
oil or compression leaks.
(10) Liquid Gasket, Locking Agent
Clean and prepare surfaces where liquid gasket or non-permanent locking agent will be used.
Apply them sparingly. Excessive amount may block engine oil passages and cause serious
damage.
(11) Press
When using a press or driver to install a part such as a wheel bearing, apply a small amount of
oil to the area where the two parts come in contact to ensure a smooth fit.
(12) Ball Bearing and Needle Bearing
Do not remove a ball bearing or a needle bearing unless it is absolutely necessary. Replace any
ball or needle bearings that were removed with new ones. Install bearings with the
manufacturer and size marks facing out, applying pressure evenly with a suitable driver. Apply
force only to the end of the race that contacts the press fit portion, and press it evenly over the
base component.
(13) Oil Seal and Grease Seal
Replace any oil or grease seals that were removed with new ones, as removal generally
damages seals. Oil or grease seals should be pressed into place using a suitable driver, applying
a force uniformly to the end of seal until the face of the seal is even with the end of the hole,
unless instructed otherwise. When pressing in an oil or grease seal, which has manufacturer's
marks, press it in with the marks facing out.
(14) Cir-clip, Retaining Ring, and Cotter Pin
When installing cir-clips and retaining rings, take care to compress or expand them only
enough to install them and no more. Install the cir-clip with its chamfered side facing load side
as well. Replace any cir-clips, retaining rings, and cotter pins with new ones, as removal
weakens and deforms them, they could become detached while the quad is driven, leading to a
major problem.
GENERAL INFORMATION
【1-3】