Panasonic KX-FT931LA-B Service Manual page 76

KX-FT931LA-B
12.3.2.1. Journal 2
Refer to JOURNAL 2 in Printout Example(P.77).
Journal 2 displays the additional detailed information about the last 30 communications.
Descriptions:
(1) RCV. MODE
Indicates which receive mode the unit was in when the unit received a fax message.
This information is also displayed when the unit transmitted a fax message.
(2) SPEED
Indicates the speed of the communication. If multiple pages are transmitted or received, it indicates the last page's communication
speed. If there is a communication error, "?" is displayed.
(3) RESOLUTION
Indicates the resolution of the communication. If multiple pages are transmitted or received, it indicates the last page's resolution. If
there is a communication error, "?" is displayed.
(4) RCV-TRIG. (CNT.)
Indicates the trigger that causes the unit to switch to the fax receive mode. The available options are listed in JOURNAL 2 in Print-
out Example(P.77). The values in parentheses indicate how many times the trigger has been used. (For example, "0003" means
three times.)
No. Display
1 FAX MODE
2 MAN RCV
3 FRN RCV
4 VOX
5 RMT DTMF
6 PAL DTMF
7 TURN-ON
8 TIME OUT
9 IDENT
10 CNG OGM
11 CNG ICM
(5) ERROR→MEMORY
Indicates the reason why the unit received a fax message in memory.
If you look at No.11 in the JOURNAL 2 in Printout Example(P.77), it shows the fax message was received in memory due to
"PAPER OUT" error.
NO RESPONSE DISAPPEARED ON JOURNAL
The "NO RESPONSE DISAPPEARED ON JOURNAL" displays the information about the last 10 communications terminated by
"No Response". (Some of the communications terminated by "No Response" were not displayed in the JOURNAL.)
When a fax transmission cannot be performed because the other party's unit is set to the TEL mode, "No response" will be printed.
Means the unit received a fax message in the FAX mode.
Means the unit received a fax message by manual operation.
Means the unit received a fax message by friendly signal detection.
Means the unit detected silence or no voice.
Means the unit detected DTMF (Remote Fax activation code) entered remotely.
Means the unit detected DTMF (Remote Fax activation code) entered by a parallel connected tele-
phone.
Means the unit started to receive after 10 rings. (Remote Turn On: Service Code #573)
Means the unit started to receive after Ring Time Out in the EXT-TAM or TEL/FAX mode.
Means the unit detected Ring Detection.
Means the unit detected the CNG while it was sending the Dummy Ring Back Tone in the TEL/FAX
mode.
OR
Means the unit detected the CNG while it was sending the OGM in the ANS/FAX mode.
Means the unit detected the CNG while it was recording the ICM in the ANS/FAX mode.
Function
76