Remove The Adapter - Broan Elite E64000 Series Installation Instructions Manual

4. REMOVE THE FILTERS AND THE GREASE DRIP RAIL
A. Remove tape on filters.
Remove filters from hood and set aside.
NOTE: It is recommended to start with the
center one(s).
B. Remove tape on grease drip rail (1).
Lift out grease drip rail and set aside.

5. REMOVE THE ADAPTER

S
INGLE BLOWER HOOD
Remove both screws retaining the adapter/damper (1) from inner top of the hood.
D
OUBLE BLOWER HOOD
First unplug both blower motors (1) before removing the 3 screws retaining the adapter (2)
to the inner top of the hood.
NOTE: The double blower hood adapter is sent unfold. See at right.
Fold the adapter and insert the male part (grey section shown in inset) into the female part
(white section shown in the inset). Then, fold over each male and female end to finalize
assembling the adapter.
A
HD0240
(INTERNAL BLOWER HOODS ONLY)
8
1
B
1
HD0259
1
HD0339
HD0284
2