Remove The Adapter - Broan Elite E64000 SERIES Installation Instructions Manual

4. REMOVE FILTERS AND GREASE DRIP RAIL
A. Remove tape on filters.
Remove filters from hood and set
aside.
NOTE: It is recommended to start
with the center one(s).
B. Remove tape on grease drip rail (1).
Lift out grease drip rail and set
aside.

5. REMOVE THE ADAPTER

SINGLE BLOWER HOOD
Remove both screws retaining the adapter/damper (1) from inner top of
the hood.
D
OUBLE BLOWER HOOD
First unplug both blower motors (1) before removing 3 screws retaining the
adapter (2) from inner top of the hood.
Fold the adapter and insert the male part (grey section shown in inset) into
the female part (white section shown in the inset). Then, fold over each
male and female end to finalize assembling the adapter.
A
HD0240
(INTERNAL BLOWER HOODS ONLY)
- 8 -
1
B
1
HD0259
1
2
HD0283
HD0284