Listening To Auxiliary Equipment; Transmitting Sound On Fm Wave - JVC RV-NB10B Instructions Manual

■ ■

Listening to auxiliary equipment

Number buttons
AUX
You can listen to auxiliary equipment with the following methods:

• Transmitting sound on FM wave

• Connecting to the AUX IN jack
Note: For operation of the auxiliary equipment, refer to its instructions.
■ Transmitting sound on FM wave
You can connect auxiliary equipment such as a digital audio player to the wireless transmitter, then transmit the sound signals on FM wave.
■ Installing the batteries to the wireless
transmitter
Match the polarity (+ and –) on the batteries with the +
and – markings in the battery compartment.
R6(SUM-3)/AA(15F)
(supplied)
WIRELESS/
PRESET TUNING
FM/AM
FM MODE
AUX
Listening to auxiliary
equipment
■
1.Connect the wireless transmitter to the
headphones jack of auxiliary equipment.
■
2.Select one of the position numbers on the
wireless transmitter.
• To check the assigned frequency to each the position number,
refer to the label put on the rear of the wireless transmitter.
• Make sure that no local FM station in you area uses the same
frequency.
■
3.Turn on the wireless transmitter.
The red lamp lights up.
• To select a position number from P1 - P4, set the switch to
LOW POSITION.
• To select a position number from P5 - P8, set the switch to
HIGH POSITION.
■
4.Set the volume level of the system to
minimum.
WIRELESS/
FM/AM
Continued on the next page...
16