Av Compu Link Remote Control System - JVC RX-D401S Instructions Manual

AV COMPU LINK
remote control
system
The AV COMPU LINK remote control system allows you to
operate JVC's video components (TV, DVD player*, and VCR)
through this receiver.
This receiver is equipped with the AV COMPU LINK-III, which has
added a function to operate JVC's video components through the
component video jacks. To use this remote control system, you
need to connect the video components you want to operate,
following the diagrams below and the procedures on page 37.
• Refer also to the manuals supplied with your video components.
* "DVD player" on pages 38 and 39 can be replaced with "DVD
recorder."
Connections 1: AV COMPU LINK connection
AV AV
COMPU LINK-III COMPU LINK EX
Monaural mini-plugs
(not supplied)
Monaural
mini-plugs
(not supplied)
IMPORTANT:
• The AV COMPU LINK remote control system cannot control the
DBS tuner connected to the DBS IN jacks.
• When "VIDEO OUTPUT" is set to "VIDEO
26), the AV COMPU LINK remote control system may not
operate properly. In this case, do not make the AV COMPU
LINK connection.
38
TV
AV
COMPU LINK- III
AV
COMPU LINK
DVD player
AV
COMPU LINK
VCR
< >
HDMI " (see page
NOTES
• When connecting the receiver and a TV with the AV COMPU LINK
EX terminal by using a component video cable, you cannot use
Automatic selection of TV's input mode (see page 39).
• When connecting only the VCR and DVD player to this receiver,
connect it directly to the receiver using cable with the monaural
mini-plugs.
• You can connect only the TV with AV COMPU LINK EX or AV
COMPU LINK-III terminal to the AV COMPU LINK-III terminal.
Connections 2: Video cable connection
This receiver is equipped with three types of the video terminals
other than the HDMI terminals—composite video, S-video, and
component video, and the signals coming into this receiver
through one type of video terminals can output only through the
terminal of the same type. So you need to connect the video
components to this receiver using one of the following three ways.
• When using the AV COMPU LINK remote control system, set
the video output and video input setting for the DVD player and
the VCR correctly (see "Selecting the video input setting" on
page 16 and "Selecting the output video signals—VIDEO
OUTPUT" on page 26); otherwise, the correct input for this
receiver will not be selected on the TV.
Case 1:
When connecting the source equipment to the receiver
through the S-video terminals, connect this receiver to the
TV's video input 1 terminal using S-video cables.
S-video cable
Source
RX-D401S
equipment
RX-D402B
Case 2:
When connecting the source equipment to the receiver
through the composite video jacks, connect this receiver
to the TV's video input 2 terminal (composite video input)
using composite video cables.
Composite video cable
Source RX-D401S
equipment RX-D402B
Case 3:
When connecting the source equipment to the receiver
through the component video jacks, connect this receiver
to the TV's video input 2 terminals (component video
input) using component video cables.
Component video cable
Source RX-D401S
equipment RX-D402B
S-video cable
TV
To video input 1
Composite video cable
TV
To video input 2
(Composite)
Component video cable
TV
To video input 2
(Component)