Remote; Remote Control Functions - JVC HR-XVC33U Instructions Manual

72
EN
Remote Control
Functions
Remote A/B/C/D Code Switching
The Remote is capable of controlling four JVC video units
independently. Each of units can respond to one of four codes
(A, B, C or D). The remote control is preset to send A code
signals because your unit is initially set to respond to A code
signals. You can easily modify your unit to respond to B, C or D
code signals.
Before performing the following steps:
Slide the TV/VCR/DVD switch to the right.
On the Remote
Keep pressing VCR down during steps A – B.
A
Change the remote control code.
Press the number key "1" for A, "2" for B, "3" for C or
"4" for D.
B
Set the remote control code.
Press OK to set the code.
On the unit
C
Turn off the unit.
Press POWER (1).
D
Display the code.
Press PLAY (4) on the unit for over 5 seconds while the
unit is turned off. The code currently set appears on the
front display panel.
● If the code displayed on the front display panel is different
from the code set on the Remote, go to step E.
E
Change the unit's code.
Press STOP (8) on the Remote. The code currently set on
the Remote will be applied to the unit.
NOTE:
Once you unplug the end of the mains power cord from the
mains, the remote control code is back to A.

REMOTE