Edit To Or From Another Video Recorder - JVC HR-XVS44U Instructions Manual

Edit To Or From
Another Video
Recorder
A
TV receiver Player
S-Video cable
Audio/video cable
AV mode
Recorder
B
Your unit Recorder
S-Video cable
Audio/video
cable
Another recorder
Player
Advantages of S-VHS video recorders
You can edit from VHS to S-VHS, S-VHS to VHS, or, from
S-VHS to S-VHS.
From VHS to S-VHS: Record VHS playback signals in the
S-VHS mode. Although the picture quality is inherently
limited by that of the original, the edited tape has better
picture quality than those made by VHS-to-VHS editing.
From S-VHS to VHS: Because the picture quality of the
source material is very high, the edited tape has better
picture quality than those made by VHS-to-VHS editing.
From S-VHS to S-VHS: All signals will be transferred with
minimum degradation.
Your unit
Audio/video
cable
Another recorder
TV receiver
AV mode
Audio/video
cable
You can use your unit as the source player or as the
recording deck.
Slide the TV/VCR/DVD switch to the right.
A
Make connections.
A When using your unit as the source player ...
... connect its AUDIO/VIDEO OUTPUT connectors to the
audio/video input connectors on another recorder.
B When using your unit as the recording deck ...
... connect its AUDIO/VIDEO INPUT connectors to the
audio/video output connectors on another recorder.
If connecting a unit with an S-VIDEO input/output connector,
it is recommended to use the supplied S-Video cable to
minimize picture degradation while editing.
B
Select the VCR deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the Remote
Press VCR so that the VCR indicator lights up.
C
Set the input mode of recording deck.
With this video unit, press AUX (number key "0") and/or
CH to select "L-1".
When using S VIDEO connector, set "REAR AUX INPUT" to
"S-VIDEO". ( pg. 79)
When using VIDEO connector, set "REAR AUX INPUT" to
"VIDEO". ( pg. 79)
When using another recorder as the recording deck, refer to its
instruction manual.
D
Set the edit mode.
See "PICTURE CONTROL" on page 76.
E
Engage the Record Pause mode of the
recording deck.
Locate the point where you start recording, then engage
the Record Pause mode.
F
Start the source player.
Engage the Play mode of the source player.
G
Start the recording deck.
Engage the Record mode of the recording deck.
NOTES:
All necessary cables can be obtained from your dealer.
When you select "EDIT" to dub tapes in step D, be sure to
select "AUTO" (or "NORM" when "VIDEO CALIBRATION" is
set to "OFF") after you finish dubbing the tapes.
When you use this unit as the source player for editing, be sure
to set "SUPERIMPOSE" to "OFF" before starting. (
69
EN
pg. 77)