Advertisement
When the control knob isturned ON, gas will flow intothe burner. The solid state igniter
will click until the gas is ignited. (Note: All burner igniters will spark regardless of which
burner is being operated.) Jfthe burner flame shouJdgo out, the automatic reignition
system will automatically spark to reignite that burner. This feature is provided as a
convenience. It is not intended to be interpreted as a safety feature.
A properly adjusted burner with clean ports will light within a few seconds. The cone-
shaped flame will be clear blue in color with a clearly defined inner cone. There should
be no trace of yellow in the flame. If the burner flame is yellow, lifts off the ports, or is
noisy, the air/gas mixture may be incorrect. Therefore, contact a service technician to
make the needed adjustment.
The infinite surface controls provide flexibility in heat setting selection. (See page 7)
In case of prolonged power failure, you can manually light the surface burner by holding
alighted match nearthe burner ports and elowlyturning the control knobcounterclockwise
(after depressing) to the Hi setting.
Note:
Do not leave cooktop unattended when cooking during a power failure. The
automatic reignition feature of your cooktop will not operate during a power
failure.
Note:
There is no overhead hood fan so smoke and condensation can gather.
Advertisement
