Operating Modes; Alarms; Single; Double Action - ascon M3 Series User Manual

Features
Description
(at 25°C environmental temp.)
CT auxiliary input Current transformer
(option) (see page 12)

1 double

action PID
Operating mode
loop or On/Off
and Outputs
with 1 or 2

alarms

Algorithm
Proportional band (P)
Integral time (I)
Derivative time (D)
Error band
Cycle time
Dead band
Control mode
Cool relative gain
Cool cycle time
Overshoot control
High limit
Hysteresis
SPST Relay N.O., 2A/250V~ for resistive load
OP1 output
Triac, 1A/250V~ for resistive load
SSR drive not isolated: 5V–, ± 10%, 30mA max
OP2 output
SPST Relay N.O., 2A/250V
SPST Relay N.O., 2A/250V~ for resistive load
OP3 output
Triac, 1A/250V~ for resistive load
50 or 100 mA
input hardware
selectable
Control output

Single

OP1-Relay /Triac
action
OP2 SSR drive
Double OP1-Relay /Triac OP3-Relay /Triac
action OP1-Relay /Triac OP2 SSR drive
Heat/cool OP2 SSR drive OP3-Relay /Triac
PID with overshoot control or ON OFF
0.5...999.9%
0.1...100.0 min
0.01...10.00 min
0.1...10.0 digit
1...200 sec
-10.0...10.0%
0.1...10.0
1...200 sec
0.01...1.00
100.0...10.0% (heat) -100.0...-10.0%(cool)
0.1...10.0%
~
for resistive load
7 - Technical specification
Current visualisation 10 ... 200A
With 1A resolution
and Heater Break Alarm
AL2 alarm
OP2-Relay or SSR drive OP3-Relay/Triac
OP1-Relay /Triac
OP2-Relay or SSR drive
OP1-Relay /Triac
OFF = O
Jumper selectable
(page 13)
AL3 alarm
OP3-Relay/Triac
OP3-Relay/Triac
PID algorithm
Heat / cool
control action
PID algorithm
On-Off algorithm
Protection by
varistor
~
for 220V
and capacitor
45