Table of Contents
Advertisement
TOP AND FRONT OF ENGINE
11
Cylinder head gasket
REFITTING (special notes)
Fit the cylinder head gasket. This is centred by two
dowels.
Bring the pistons to mid-stroke position to prevent
them from coming into contact with the valves as the
cylinder head is tightened.
Centre the cylinder head on the dowels.
Lubricate the threads and under the heads of the
mounting bolts.
Tighten the cylinder head using an angular tightening
wrench (see section '07 "Tightening the cylinder
head").
Tightening procedure for the automatic tensioner
mounting
Offer up the three touching bolts then apply a torque of
2.5 daN.m respecting the order shown below.
PRF1102
Refitting is the reverse of removal.
Refit the timing belt, (see procedure described in
section 11 "Timing belt").
Fill and bleed the cooling circuit, (see section 19
"Filling and Bleeding").
To reprime the diesel circuit, consult section 13, "Fuel
filter".
11-12
- Quick Links:
- Timing Belt
Hide quick links:
Advertisement
Table of Contents
