Renault 2000 Megane Technical Note page 28

Special features of vehicles fitted with air
conditioning:
Before removing the accessories belt, check the
centreline of the automatic tensioner (see
section 07 "Checking the accessories belt
tension").
Loosen bolt (A), then bolt (B) to past the shoulder
while holding the automatic tensioner plate using a
9.35 mm square, then relax the belt moving the
ratchet in the direction of the arrow.
Remove the Top Dead Centre pin plug.
Position the engine support, tool Mot. 1453 with the
retaining straps.
TOP AND FRONT OF ENGINE
Timing belt
98837-1R4
13932R
11-2
Remove:
– the suspended mounting cover and its movement
limiter.
– the bolt (1), and slacken engine tie-bar bolt (2),
without removing it.
Adjusting the timing
Turn the crankshaft to align the camshaft and housing
timing marks while at the same time inserting the TDC
pin Mot. 1054 (begin to press one half tooth on the
pin before aligning the camshaft marks to prevent
it falling into a crankshaft balancing hole).
11
17518R3
12518R2