Maintenance Schedule - Land Pride 357-398M Operator's Manual

Zero turn mowers

Hide thumbs

Table Of Contents

Table of Contents

Section 5: Maintenance & Lubrication

Service at Intervals Indicated

Clean mower, Deck & Engine Cooling System

Verify Safety Start Interlock System

Inspect Unit for loose hardware and damage

Visually Inspect Tires

Check Engine Oil Level

Clean Air Intake Screen

Check Fuel Level

Inspect Fuel System for Leaks

Check Blades - Sharp & Securely Fastened

Check Discharge Chute -

Make sure it is Properly Secured In Place

Grease Blade Spindle Bearings

Change Engine Oil & Filter (1)

Clean Cylinder And Head Fins

Check Battery Connections

Check Tire Press With A Gauge

Clean Engine Exterior (3)

Check hydraulic Oil Level

Tighten Lug Nuts On Wheels (2)

Grease Caster Wheel Bearings

Check Ground And Deck Belt Tension (4)

Check Hydraulic system (5)

Change Fuel Filter (3)

Grease Deck Lift Pivot Points (8)

Replace Spark Plugs(3)

Replace Air Cleaner Paper Element (6)

Inspect fuel caps (8)

Grease Front Axle Center Pivot (8)

Grease Tele-Caster

Spindles

Grease Idler Arm Pivot Pin (8)

Change Hydraulic oil & Filter (7) (8)

Check and Adjust Parking Brakes (8)

NOTES:

1. Initial engine oil and oil filter change is after the first 5 hours of operation. Thereafter, change engine oil and oil filter

every 50 hours of operation. Change every 25 hours when operating the engine under dusty or dirty conditions,

heavy load, high temperatures and hot weather periods. Refer to Engine Owner's Manual.

2. Torque lug nuts initially and after first 2 hours of operation.

3. Remove cooling shrouds and clean cooling areas. Check oil cooler fins and clean as needed. Refer to Engine

Owner's Manual.

4. Inspect ground and deck belt tensions every 6 months or 100 hours and replace if worn or cracking is noticed.

Otherwise, replace every 200 hours or 2 years whichever comes first.

5. Inspect all hydraulic system components for leaks and repair as necessary. Replace any hoses that are cracked

or damaged.

6. Replace air cleaner filter element if damaged, every 200 hours or every season (whichever comes first). Replace

more frequently when used in dusty conditions.

7. Initial hydraulic oil and filter change is between 25 and 50 hours of operation.

8. X/M = Service per hours indicated in column or monthly (whichever comes first).

X/A = Service per hours indicated in column or annually (whichever comes first).

4/1213

Table of Contents