Table of Contents
Advertisement
Section 1: Assembly & Set-up
ZT72i Seat Assembly
Refer to Figure 1-3:
The seat (#1) is shipped factory mounted to the hinged
seat platform (#4) and attached to the shipping crate with
three lag bolts. It should have already been removed in
step 1 under "Uncrating Instructions" on page 10. If not,
remove it now.
IMPORTANT: Be careful not to cut seat material
when removing protective packing around the seat.
Cutting seat material will void its warranty.
1. Spread control levers (#2) fully apart before
attaching the seat platform to the mower frame.
2. Pivot both arm rests (#9) on the seat up.
3. Pivot back side of seat platform (#4) up about 45
degrees and insert platform tabs through slots in the
mower platform and onto pins just below the slots.
4. Connect mower switch wires to the seat switch
located under the seat.
Refer to Figure 1-4:
5. Hinge seat platform down. The platform will latch
automatically. The following must be done if the seat
platform does not fit over pilot pin (#2).
a. Loosen 3/8"-16 hex socket head cap screw (#1).
b. Adjust pilot pin (#2) to be centered in the seat
platform pin hole.
c. Tighten 3/8"-16 hex socket head cap screw (#1).
6. Being careful not to cut seat material, remove
protective packing around seat.
7. See "Seat Adjustment" on page 27 for positioning
this seat forward and rearward.
ZT72i Seat Belt Assembly
Refer to Refer to Figure 1-5:
1. Insert seat belt clip (#4) with push button "A" into clip
sleeve (#5).
2. Make sure push button "A" is facing out as shown.
Insert 7/16" bolt (#1A) through flat washer (#3), seat
belt clip & sleeve (#4 & #5), mounting hole "B" and
flat washer (#3). Secure bolt with nylock nut (#2).
Rotate seat belt up to the approximate angle shown
and tighten nylock nut to 36 ft-lbs. of torque.
3. Orient seat belt retractor (#6) with spring retractor
facing out as shown. Insert 7/16" bolt (#1B) through
flat washer (#3), mounting hole "C", seat belt
retractor (#6) and flat washer (#3). Secure bolt with
nylock nut (#2). Rotate seat belt retractor to the
approximate angle shown and tighten nylock nut to
36 ft-lbs. of torque.
4/1213
Table of Contents
Platform
Tabs
Pins Below
Slots in Plate
Control Lever & Seat Assembly (Standard Seat Shown)
2
Pilot Pin (#2) must be centered in
seat platform pin hole.
Seat Belt Retractor (#6) Must Be Mounted This
Side Of Mounting Hole "C" To Keep Retractor
From Interfering With Right Side Fuel Tank.
Seat Belt Assembly (Deluxe Seat Shown)
Suspension Seat Includes Seat Belt Mounting holes (B)
ZT60i & ZT72i (S/N 748109-) Accu-Z
Figure 1-3
1
Seat Latch Adjustment
Figure 1-4
Figure 1-5
®
Zero Turn Mowers 357-398M
30091
30092
30213
Spring Retractor
11
Advertisement
Table of Contents
