Basic Operations; Turn On The Power; Select The Source To Play - JVC RX-E11S Instructions Manual

Basic operations

1
1
2
When operating the receiver
using the remote control, set
the mode selector to
3
"AUDIO/TV/VCR/DBS."
1

Turn on the power

Press STANDBY/ON (or
remote control).
The standby lamp goes off and the source lamp of the current
source lights in red.
Current source name appears.
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS
PL
LPCM L C R
DOLBY D NEO : 6
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
To turn off the power (into standby)
Press STANDBY/ON (or
again.
The standby lamp lights in red.
NOTE
A small amount of power is consumed in standby mode. To turn
the power off completely, unplug the AC power cord.
10
2 3
AUDIO on the
TUNED ST AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
AUDIO on the remote control)
2

Select the source to play

On the front panel:
Turn SOURCE SELECTOR until the source name
you want appears on the display.
The source lamp corresponding to the selected source lights in
red.
• As you turn SOURCE SELECTOR, the source changes as
follows:
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS
LPCM L C R PL
DOLBY D NEO : 6
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
DVR/DVD (DGT)
DBS (DIGITAL)
FM AM
(Back to the beginning)
DVR/DVD (DGT) * : Select the DVD recorder or DVD player.
*
VCR (DIGITAL) : Select the VCR.
*
DBS (DIGITAL) : Select the DBS tuner.
*
TV (DIGITAL) : Select the TV.
FM: Select an FM broadcast.
AM: Select an AM broadcast.
From the remote control:
Press one of the source selecting buttons.
* Selecting the analog or digital input mode
For a component you have connected using both the analog
connection and the digital connection methods (see pages 7 to 9),
you need to select the correct input mode.
• You can select the digital input only for sources which you have
selected digital input terminals for. (See "Setting the digital input
(DIGITAL IN) terminals—DIGITAL IN1/2/3" on page 19.)
From the remote control ONLY:
Press SOUND, then press A/D INPUT to select
the analog or digital input mode.
• Each time you press A/D INPUT, the input mode alternates
between the analog input ("ANALOG") and the digital input
("DGTL AUTO").
DGTL AUTO: Select for the digital input mode. The receiver
automatically detects the incoming signal
format, then the digital signal format indicator
(LPCM, DOLBY D, DTS, or DTS 96/24) for
the detected signal lights up.
ANALOG: Select for the analog input mode.
Initial setting: ANALOG
NOTE
After pressing SOUND, the numeric buttons work for sound
adjustments. To use the numeric buttons to operate your target
source, press the corresponding source selecting button before
operation; otherwise, the remote control may not work as you
intend.
TUNED ST AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
VCR (DIGITAL)
TV (DIGITAL)