Epson PP-100AP User Manual page 98

❏ Do not use in a place where lots of dirt and dust are present.
❏ Leaving disc stacked may result in discs to stick to each other.
❏ Touching or splashing water drops on printing surface right after printing may result in
blurring.
❏ Let the discs dry naturally after printing. Touching the surface with your hand or
splashing the surface with water right after printing may result in blurriness and
stickiness.
❏ Printing is possible only on printing surface. When printing, use soft tipped writing
equipment like a felt pen and do not use a ball point pen. Also, do not erase once
printed.
❏ The recording surface side has a concentric ring projection called the stack ring.
Depending on the disc, projection of the stack ring is small and use of such disc may
cause the disc to stick before or after printing. It is recommended to check the disc
before use.
❏ The specified discs have a moisture-adhesive ink receptor layer on the label surface. If
stored stacked, especially under high humidity and high temperature conditions, disc
may adhere to each other. If an automatic duplication machine is used, please check
the disc before using.
Notes when storing the disc
❏ Do not store under direct sunlight, near heating equipment, or high humidity and
temperature.
❏ Do not place where large temperature variance take place as condensation may occur.
❏ Do not place object on top of it.
❏ When storing, keep the disc in its disc case and avoid letting film or cards touch the
printing surface. These may scratch the printing surface.
❏ Do not store discs in soft cases or bags which may touch the printing surface directly.
This may cause discs to stick, color shading, or discoloration.
❏ Avoid storing with part of the printing surface covered, as this may cause smearing or
dis-coloration.
❏ Avoid storing under high temperatures and high humidity, which may result in blurriness
and stickiness of the printing surface.
98
Product Information