Chapter 2
Publishing Discs
Introduction
This section guides you through the procedures for printing CD/DVD labels.
Note:
For information on CDs/DVDs, see the following section.
& See "Discs" on page 96.
Turning power on/off
This section describes how to turn on/off power.
Turning power on
1. Connect the power cable.
2. Press P power button until the power light flashes.
Power light flashes in green, then stays on.
Turning power off
Press the P power button. The
power is turned off.
Caution:
c
❏ Fan will operate after turning power off, but it will automatically stop after 15 minutes.
❏ If the product is operating, wait for 10 seconds after operation is stopped, then turn off
power.
❏ The product may not be recognized by the computer when the power is turned back on
while fan is operating. In this case, disconnect the USB cable and connect it again.
Overview of publishing mode
To print labels that you have created/edited is called "Publish" in EPSON Total Disc Maker.
The product has three kinds of publishing modes.
power light will flash in green then turn off; then
20
Publishing Discs