Electrical Power Windows - Skoda Citigo Owner's Manual

26 Unlocking and locking
Folding in the key bit
– Press button 4 and fold in the key bit.
The turn signal lights flash twice as confirmation that the vehicle has been un-
locked. The vehicle will lock again automatically and the safe securing system will
be activated again if you unlock the vehicle using button
door or the boot lid within the next 30 seconds. This function is intended to pre-
vent the car being unlocked unintentionally.
Display of the locking
The turn signal lights flash once to confirm that the vehicle has been correctly
locked.
If the vehicle is locked by pressing the button
are not closed, the turn signal lights flash only after closing.
WARNING
If the car is locked from the outside and the safe securing system is activated,
there must not be any person in the car as it is then not possible to open ei-
ther a door or a window from the inside. The locked doors make it more diffi-
cult for rescuers to get into the vehicle in an emergency - hazard!
Note
● Operate the remote control only when the doors and boot lid are closed and
you have visual contact with the vehicle.
● Once in the car, you must not press the lock button
control before inserting the key into the ignition lock in order to avoid the car be-
ing inadvertently locked. Should this happen, press the unlock button
dio remote control.
Synchronising the remote control
If the vehicle cannot be unlocked by actuating the remote control system then it
is possible that the code in the key and the control unit in the vehicle are no lon-
ger synchronised. This can occur when the buttons on the radio-operated key are
actuated a number of times outside of the operative range of the equipment or
the battery on the remote control was replaced.
This means it is necessary to synchronise the code as follows:
– Press any button on the remote control.
1 but do not open a
and some doors or the boot lid
3
of the radio remote

of the ra-

Pressing of the button means that the door will unlock with the key within 1
–
minute.

Electrical power windows

Buttons for electrical power windows
The power windows operate only when ignition is switched on.
Opening a window
– A window is opened by pressing lightly on the respective button in the door.
The opening process stops when one releases the button.
Closing a window
A window is closed through pulling lightly on the respective button in the
–
door. The closing process stops when one releases the button.

The buttons for the individual windows are located in the operating part of the
⇒ F ig.
armrest of the driver's door
WARNING
● If you lock the vehicle from the outside, do not leave any person in the ve-
hicle since it is no longer possible to open the windows from the inside in an
emergency.
● When closing the windows proceed with caution to avoid causing crushing
injuries - risk of injury!
Fig. 17 Button on the driver's door
17, and in the front passenger door.

£