Skoda Citigo Owner's Manual page 12

The multi-functional indicator is equipped with two automatic memories. The se-
lected memory is shown in the Display
The data of the single-trip memory (memory 1) is shown if a 1 appears in the dis-
play. A 2 shown in the display means that data relates to the total distance mem-
ory (memory 2).
Switching over the memory takes place with the button
shield wiper lever.
Single-trip memory (memory 1)
The single-trip memory collates the driving information from the moment the igni-
tion is switched on until it is switched off. New data will also flow into the calcula-
tion of the current driving information if the trip is continued within 2 hours after
switching off the ignition. If the trip is interrupted for more than 2 hours, the
memory is automatically erased.
Total-trip memory (memory 2)
The total distance driven memory gathers data from any number of individual
journeys up to a total of 19 hours and 59 minutes driving or 1 999 kilometres driv-
en. The memory is deleted when either of these limits is reached and the calcula-
tion starts from anew.
The total-trip memory will not, contrary to the single-trip memory, be deleted af-
ter a period of interruption of driving of 2 hours.
Note
All information in the memory 1 and 2 is erased if the battery of the vehicle is dis-
connected.
Operation
Using the system Safety
⇒ F ig.
5.
⇒ F ig. 6
on the wind-
B
Fig. 6 Multi-functional indicator: Control
elements
Driving Tips
The rocker switch and the button
A
⇒ F ig.
6.
Select memory
– Short-term pressing of the button
select the desired memory.
Selecting functions
– Briefly press the rocker switch
the individual functions of the multi-functional indicator.
Reseting
Select the memory you want.
–
– Press button B for more than 1 second.
The following readouts of the selected memory will be set to zero by button
● average fuel consumption;
● distance driven;
● average speed;
● Driving time.
You can only operate the multi-functional indicator when the ignition is switched
on. After the ignition is switched on, the function displayed is the one which you
last selected before switching off the ignition.
Digital clock

The time is set as follows:
⇒ F ig. 6
– Press the rocker switch A
time.
⇒ F ig. 3
Press the button 6
–
⇒ F ig. 3
– Press button 3 to continue setting the time. Keep the button pressed
to run through the numbers quickly.
– Press the button 6 again to select the minutes display so that it flashes.
– Press button 3 to continue setting the time. Keep the button pressed to run
through the numbers quickly.
– Confirm the set value by pressing the button
seconds. The setting is saved automatically (the value stops flashing).
General Maintenance Do-it-yourself
Instruments and warning lights
are located on the windshield wiper lever
B
B on the windshield wiper lever allows to
A up or down. In this way, call up in sequence
up or down to change the display of the
to select the hour display so that it flashes.
6 again, or wait for around 5
Technical data
11
B :

