Connections; Connecting The Fm And Am (Mw) Antennas - JVC GVT0155-001A Instructions Manual

Connections

Connecting the FM and
AM (MW) antennas
7 AM (MW) loop antenna
Setting up supplied AM (MW) loop antenna
                                    
coat, twist and pull the insulation coat off and
remove.
Connecting AM (MW) loop antenna
1
2
Antenna cord
3
• Turn the loop antenna until you have the best reception during
AM (MW) broadcast program reception.
NOTE
• Make sure the antenna conductors do not touch any other terminals,
connecting cords and power cords. This could cause poor reception.
7
power cord until all other connections have been made.
            
           
AM (MW) loop
Outdoor single vinyl-covered wire
antenna (not supplied)
7 FM antenna
Center unit
If reception is poor
Center unit
Standard type (75 C
coaxial) connector
NOTE
We recommend that you use coaxial cable for the FM antenna as it is
well-shielded against interference.
antenna
FM antenna (supplied)
Extend the supplied FM antenna
horizontally.
Outdoor FM antenna
(not supplied)
Outdoor FM antenna cord
(not supplied)
Center unit