References; Troubleshooting - JVC AX-THL1 Instructions Manual

References

Troubleshooting

PROBLEM
Power does not come on.
POWER
The system suddenly
turns off.
The remote control does
not work.
REMOTE
CONTROL
The remote control does
not work as expected.
No sound.
SOUND
No picture is displayed on
the TV screen.
No picture is displayed on
the TV or no sound come
out through HDMI
connection.
PICTURE
No picture is displayed on
the TV screen, the picture
is blurred, or the picture is
divided into two parts.
The picture does not fit
the TV screen.
The iPod does not play
even though
"CONNECT" appears on
the display.
The iPod is not charged.
PLAYBACK
Video and audio are
distorted.
Surround modes of
"DOLBY DIGITAL" or
"dts SURROUND" are
not available to use.
32
POSSIBLE CAUSE
The power cord is not connected.
The playback level of the current
source is too high.
The batteries are exhausted.
Sunlight is shining directly on the
remote sensor.
The remote control mode is not for
the desired source.
The speaker cord is not connected.
An incorrect source has been selected. Select the correct source. (See page
The video cord is not connected
correctly.
The file is not playable.
The connected TV is not HDCP-
compatible.
The HDMI cord is not connected
correctly.
The scan mode is set to "PROGRESS"
though the center unit is connected to
the TV which does not support the
progressive video input.
The monitor type is not set correctly.
The battery of the iPod is exhausted.
The iPod battery charge function is
deactivated.
The iPod is not compatible with the
System.
The source is not "iPod. "
The iPod battery charge function is
deactivated.
A video component is connected
between the center unit and the TV.
"ANALOG" is selected on the setting
of the audio terminals.
The external component is not
connected with the digital audio cord
(coaxial or optical) or HDMI cord.
SOLUTION
Connect the power cord correctly.
(See page 13.)
Play back the source with lower
volume level.
Replace the batteries. (See page 6.)
Hide the remote sensor from direct
sunlight.
Before operation, press one of the
source selecting buttons for the
desired source.
Check the connection. (See page 7.)
16.)
Connect the cable correctly. (See page
9.)
Use a playable file. (See pages 3.)
Use a HDCP-compatible TV.
Disconnect the HDMI cable and
connect it again.
Change the scan mode to "INT-
LACE". (See page 18.)
Set "MONITOR TYPE" properly. (See
page 29.)
Leave the iPod connected for at least
10 minutes.
Activate the iPod battery charge
function. (See page 19.)
Check the compatibility on the list.
(See page 19.)
Change the source to "iPod. " (See
page 16.)
Activate the iPod battery charge
function. (See page 19.)
Connect the center unit and TV
directly. (See page 9.)
Select "DIGITAL" on the setting of the
audio terminals.
Connect the external component with
the digital audio cord (coaxial or
optical) or HDMI cord. (See pages 10
to 12.)